Guide
Bend & Vibrato Trainer: how to practice with it
The Bend & Vibrato Trainer listens to one note at a time and draws its pitch when the note ends. You see how far you bent it, how close it landed to the note you were aiming for, and how fast, wide, and even your vibrato was. This page covers how to set it up, then how to practice bends and vibrato with it.
Setting up
Plug in if you can. The trainer hears best with your guitar going through an audio interface. A phone's or laptop's built-in microphone often cuts a note short, so a long bend or vibrato may only be drawn in part. If you play an electric through an amp, you can also put a microphone near the amp. Choose your input in Settings.
Tune first. Every measurement is against in-tune pitch, so a guitar that's 15 cents flat makes every bend look 15 cents flat. The Tune up button opens the site's tuner without leaving the page.
One note at a time. Pick a note, bend it or add vibrato, and let it ring or mute it. The trainer waits for the note to end, then draws it. A clean tone works best. Keep the other strings quiet, since a ringing open string can confuse the reading.
Bends: the goal is in tune
A bend has one job: land on the note you're aiming for, in tune. For each note, the trainer shows the bend's size in cents (100 cents is one fret) and how far it landed from the target, short or over. Under the plot it keeps statistics for the whole session, one row per interval, since a half step and a whole step can miss in different ways:
- The average says whether you tend to land short or over.
- The spread says how consistent you are. About two-thirds of your bends land within one spread of the average.
Start with whole-step bends on the B and G strings, the ones you'll use most. Then add half steps and step-and-a-half bends, and try other strings and positions. Pre-bends and releases are measured the same way. The exercises in How to practice bending… in tune are a good set to work through.
Watch first, then listen. When you're starting out, keep your eyes on the plot while you bend. You'll see the line rise toward the target, and you'll hear what it sounds like when it gets there. That's how you get the sound of an in-tune bend into your ears. Once you can hear it, stop watching while you play. Bend the note by ear, and only look at the screen after the note ends to see how close you got. That's the skill you'll need on stage, where there's no screen to watch.
Press Clear notes before each new set, for example ten whole-step bends on the G string, so the statistics cover just that set. Over a few sessions, the average should move toward zero and the spread should shrink.
Vibrato: even and controlled
There isn't one right vibrato. When I measured the vibrato of nine guitar heroes, David Gilmour's typical vibrato swung about 55 cents at 5.8 swings a second, B.B. King's 60 cents at 7.2, and Angus Young's 160 cents at 6.9. That post covers what vibrato is made of (speed, width, and how long a note is held before the vibrato starts) and what great players do with each. Read it first, and pick a sound you're aiming for.
What the great players have in common is control: the swings are even, and the speed and width are a choice, not an accident. The trainer measures four things about each vibrato:
- Speed: swings per second, in hertz (Hz).
- Width: how far each swing goes, in cents.
- Cleanness: how close the vibrato is to a steady, even wave. 100% is perfectly smooth. Shaky or uneven swings bring it down.
- Before the vibrato: how long you held the note straight before the vibrato began.
On a fretted note, each swing should come back down to the note you're fretting. The trainer tells you whether every swing did, or how many stopped short. Not releasing all the way pushes the whole note sharp.
On a bent note, bend to the note first and get it in tune, then add the vibrato. The trainer reads the vibrato against the note you bent to. In the solos I measured, most bent-note vibratos swing evenly above and below that note.
Start slow and narrow, at a speed where you can keep every swing the same, and watch the cleanness. Then change one thing at a time: a little faster, or a little wider. Try holding a long note straight for half a second before the vibrato comes in, the way Gilmour sometimes does. The bracket on the plot shows how long you held it.
Reading the plot
Time runs left to right from the pick. Each horizontal line is one fret, named on the left and counted from the fretted note on the right, so a whole-step bend should land on +2. The tinted band around each line is within 10 cents of the note. The dashed gray line is where you fretted the note, and the dashed orange line is where the bend landed. The blue band is the vibrato, with a dot on every turning point, and the green bracket is how long the note was held before the vibrato began.
Only notes with a bend or vibrato are kept in the list. A plain fretted note is drawn but not kept. If the trainer misreads a note, Remove it from the list drops it from the statistics. The list lasts until you reload the page.
The sound never leaves your device.