Fret Science

Bend & Vibrato Trainer Beta

In-tune bends and smooth vibrato separate great players from the merely good ones, and they’re easy to neglect, partly because it’s hard to tell how you’re doing while you practice them. This trainer gives you immediate feedback on every note.

Start listening, then play one note at a time. Each note is drawn when it ends, with its bend in cents, its vibrato’s speed and width, and how long you held it before the vibrato began. Notes with a bend or vibrato are kept below, with statistics over all of them. How to practice with it

Use an audio interface if you can.The trainer reads best with your guitar plugged into an audio interface. A phone’s or laptop’s built-in microphone often cuts notes short, so a long bend or vibrato may be drawn only in part.

A sample note: a whole-step bend from G to A on the B string, with vibrato once it lands.

Bend
+185 c
a whole step to A4, 15 c short
Vibrato speed
5.6 Hz
5 cycles, uneven
Vibrato width
22 c
below A4, −18 to +4 c
Cleanness
64%
a little shaky: how close to a sine wave
Before the vibrato
1.93 s
after the pick; 0.93 s after the bend landed
  • Fretted at G4, 6 c sharp.
  • The bend landed on A4 −15 c, 0.52 s after it began rising.
  • The vibrato's middle sits at −7 c from A4; it ran 0.9 s.
  • The note lasted 3.3 s.

This is a sample note

The trainer draws every note you play this way, keeps the ones with a bend or vibrato, and tracks how close your bends land to pitch over a whole session.

A Silver membership or higher unlocks it. Already a member? Sign in with the account linked to your Patreon membership.

Reading the plot

Time runs left to right from the pick. Each line is a semitone, one fret, named on the left and counted from the fretted note on the right, so a whole-step bend should land on +2. The tinted band around each line is within 10 cents of the note. A bend is measured against these lines, not from wherever it started: its cents count from the fretted note’s line, and short or over means how far it landed from the line it was aimed at. A vibrato is read against its note’s line too, so you can see whether each swing comes back down to it.

The dashed gray line is where you fretted the note, and the dashed orange line is where the bend landed. The blue band is the vibrato, with a dot on every turning point, and the green bracket is how long the note was held before the vibrato began.

Cleanness is how close the vibrato is to a steady sine wave: 100% is perfectly smooth and even, a square-shaped swing scores about 80%, and shake or uneven cycles bring it down. A short break in the pitch doesn’t end the note; the tool reads straight through it.

Session statistics

Only notes with a bend or vibrato go in the list under the plot; a plain fretted note is drawn but not kept. The list holds the last 100 notes, and the statistics below it cover every note in it. For the bends, the average is how far they landed from their in-tune notes on the whole, short or over, and the spread (the standard deviation) is how much they varied around that: roughly two-thirds of bends land within one spread of the average. Each interval gets its own row, since a half step and a whole step can miss differently. Fretted and bent vibrato are counted apart.

Clear notes starts a new set, for instance before a scale played all in bends, and Remove it from the list drops a note the tool misread. Reloading the page clears the list too.

The sound never leaves your device. The tool listens only while it says so.